IMPORTANT INFORMATION

Please follow these guidelines with your New pressure washer

1.                 Assemble your New pressure washer on level ground and read through the manual to get familiar with your new product

2.                 Fill Engine oil to the point of overflowing with 10/30 or 15/40 mineral oil, once you see oil starting to trickle out you have enough oil. No need to tip the machine, keep it level.

(Do not use synthetic oil)

3.Then fill the water pump with 3 in 1 oil, (Filler is on top of pump)

4.     Fill with UNLEADED Petrol

5.     Before you start the engine you must PRIME the water pump, do this by having water connected and running to the pump.

6.     You are now ready to start using your machine

7.     Petrol switched on

8.     Choke on

9.     On/off switch on

10. Pull recoil until engine starts

11. Once running, slide choke lever to off

12. Please do not leave pressure washer running unattended

13.Never leave it running without squeezing the trigger for more than 5 minutes, this will build up a lot of pressure and can damage the water pump